CynkoMet N-235 Series, Инструкция по использованию и эксплуатации

Страница: 74 / 124

Cynko Met
N-233
74
7. Transport
The spreader is prepared for sale in a complete state and does not
require packing. Only the instruction manual of machine handling and the
connecting cable of the electrical system undergo packaging.
The delivery of the spreader to the user is done by independent
transport after connecting with the tractor or automobile (in this case, the
spreader because of the height can be mounted on the platform of the
transport mean on the hubs - with unscrewed and taken off wheels or on
wheels secured with chocks, but with disassembled and folded upper
extensions.
Loading and unloading of a spreader from a car should be carried out
using the loading ramp with an agricultural tractor or using a crane, lever.
During operation, observe the general safety rules with handling operations.
Persons operating the reloading equipment must have the required
permissions to use these devices.
When loading / unloading using the tractor, the spreader must be
properly connected with the tractor according to the requirements
contained in this manual. The spreader braking system must be running and
tested before running off or driving on the ramp.
When loading / unloading using a crane or a lever, the spreader is to
be lifted with the help of approved fasteners designed to carry the load with
sufficient capacity. The belts must be in good condition, they cannot show
any signs of damage.
The belts should be placed under the lower frame of the spreader in
such places that when lifting the machine the belts do not have the
possibility of moving, and the spreader when moving is not tilting. If there is
a possibility of damage or frayed belts against components of the machine,
put washers in sensitive areas.
In order to avoid compression of the walls to the inside the spreader,
when loading with the use of a crane, use a special traverse, where the
places of hooking the belts will be spaced wider than the total width of the
machine.
The spreader should be attached firmly to the platform of the
transport mean with belts, chains, lashing or other fastening means
equipped with a tightening mechanism. Fastening elements are to be