Cylinda SV-DISK 3R, Руководство пользователя

Страница: 39 / 44

Max. 950 mm
The drainage hose can also be connected to a connection
nipple on the sink unit's water trap. The connection nipple
must have an internal diameter of at least 14 mm.
The drainage hose may be extended by a maximum of 3 m
(the total length of the drainage hose must not exceed 4,5
m). Any joins and connecting pipes must have an internal
diameter of at least 14 mm. However, the drainage hose
should ideally be replaced with a new hose without joins.
No part of the drainage hose may be more than 950 mm
above the bottom of the dishwasher.
Ensure that the drainage hose has no kinks.
Connection to water supply
Use only the inlet hose supplied with the dishwasher. Do
not re-use old or other spare hoses.
The supply pipe must be fitted with a water tap (stopcock).
The water tap must be easily accessible, so that the water
can be shut off if the dishwasher has to be moved.
Once the installation is complete, turn on the water tap and
allow the pressure to settle for a while. Check that all con-
nections are watertight.
Connection to cold water supply
Connect the dishwasher to the cold water supply if the
building is heated using oil, electricity or gas.
Connection to hot water supply
Connect the dishwasher to the hot water supply (max. 70
°C) if the building is heated using an energy-efficient means
such as district heating, solar power or geothermal power.
Choosing a hot water connection cuts dishwashing times
and reduces the dishwasher's energy consumption.
NOTE!
Do not exceed the permitted water supply temperature.
Certain materials used in some cookware cannot with-
stand strong heat. See Fragile dishes in the chapter
Loading the dishwasher.
Electrical connection
Information about the electrical connection can be found on
the serial number plate. This specification must match the
electricity supply.
The dishwasher must be connected to an earthed socket.
The electric wall socket must be placed outside of the install-
ation area to be easily accessible after installing the dish-
washer. Do not use an extension cord!
NOTE!
Repairs and maintenance relating to safety or perform-
ance must be carried out by a qualified professional.
Screwing the dishwasher into place
2x
= =
After fastening the machine, check that the front feet still
touch the floor.
Adjusting the plinth
The dishwasher is supplied with a toe kick. Depending on
the recess height and plinth depth the height of the toe kick
can be adjusted. The table shows which toe kick height to
use.
Recess height
Plinth depth
39
EN