ROTARY PERFORATING MACHINE RPM 350 PLUS
5
6
OPERATING INSTRUCTIONS
6.1
Preparing the machine for use
a) Read all instructions carefully before starting work on the machine.
b) To reduce the risk of injuries do not use the machine near children.
c) Check all main parts, including the electric cord, for intactness and completeness.
d) If the machine’s operation gets interrupted or the machine becomes stuck, stop working
and check the technical condition of the machine.
6.2
Input feeding table installation (1)
After unpacking the machine from packaging, push the input feeding table (1) into the machine
and secure with enclosed bolts. Connect the male part into the female part of the connector that
is place on the inside of the left side cover of the machine.
6.3
Machine start
Connect the power cord. Start the machine by pressing the power switch (7). If the protective
cover is in the closed position and paper is placed correctly on the feeding table, on display (10)
appear
0
. If the upper lid (5) is not closed properly,
E-1
or
E-2
show up on display and machine
cannot be started. If paper is missing on the feeding table, letter
P
appear and again machine
cannot be started. In case of paper jam, motor turns off automatically and
blc
show up on
display. In such case it is necessary to remove jammed paper and restart the machine.
There are two ways how to restart the machine:
1. turn the machine off and on again by main switch (7)
2. hold RESET button (9) until blc disappear. If everything all right (after paper removal), 0
display on the screen and it is possible to continue by pressing START (10)
Read more in chapter 6.4 Reading of display
After pressing START the machine automatically starts to feed the paper. By turning the same
button it is possible to control the speed. After feeding the last paper the machine stops.
1
connector bracket
