•
800 lumen LED light output
•
2 High-brightness Cree X-lamp LEDs
•
6 versatile lighting settings
High > Med > Low > Daylight Flash > 2-in-1 SteadyPulse > Walking)
•
OSP (On-Site Programmable) Technology
•
Compact Rechargeable Li-Ion battery
•
Light setting and battery level indicator
•
Smart Rapid Charger
•
Locktite tool-free handlebar mount
•
Helmet mount kit (Xtra model only)
OPERATION MANUAL
OPERATION MANUAL
OPERATION MANUAL
OPERATION MANUAL
OPERATION MANUAL
Congratulations on your purchase of the MityCross 800 high-brightness
LED headlight system. Please refer to this guide to operate your
MityCross 800 safely and properly.
Ultra Compact Rechargeable Smart Bicycle Light
If you have more questions that are not listed here,
visit the support page at:
www.cygolite.com
CAUTION:
· Headlight may get hot during use. Use caution when handling.
· Unplug the headlight from charger when not in use.
· Unplug connectors by the plug, never by the cable.
· Do not modify or substitute any parts with non-Cygolite parts.
· Do not open headlight case.
· Provide adequate airflow to the headlight to cool during use.
· If the light is on & stationary longer than 10 minutes, turn it off.
· Do not look directly at light.
· Do not operate or submerge under water.
· Do not operate the light unattended.
· Keep headlight away from combustible materials.
· Do not package headunit when hot or immediately after use.
· Carrying a flash light is recommended.
· This light is for bicycle use only.
· State laws regarding flashing bicycle lights may vary among states. Use the flashing modes
in accordance to your local state laws as well as federal law.
MITYCROSS
800
FEATURES
FEATURES
FEATURES
FEATURES
FEATURES
CONTENTS
CONTENTS
CONTENTS
CONTENTS
CONTENTS
F.A.Q.s
F.A.Q.s
F.A.Q.s
F.A.Q.s
F.A.Q.s
The MityCross 800 is designed to be used on bikes in some of the most
extreme outdoor conditions. Over time, dust and dirt may hinder the
connections on your battery and headlight. To prevent this from happening,
ensure that both the battery and headlight are clean after every ride.
Wipe the headlight and battery down with a damp cloth. Do not submerge
the battery or headlight in water. The DC jack grommet on the headlight
occasionally needs lubrication. We recommend using a bit of vaseline to
ensure easier connection between the plug and headlight. Remove all dirt
around or on the plugs or jacks on both the battery and headlight.
The High-Brightness LEDs have extensive life so bulb replacement is not
required.
CARE
CARE
CARE
CARE
CARE
The headlight will not turn on.
•
Make sure the power button was firmly pressed.
•
Make sure the battery cable is properly connected.
•
Make sure the battery is fully charged.
The headlight turns off over rough terrain.
•
Make sure battery cable is securely plugged into the headlight.
•
Make sure battery cable is fastened to the handlebar to
minimize cable vibration.
TROUBLESHOOTING
TROUBLESHOOTING
TROUBLESHOOTING
TROUBLESHOOTING
TROUBLESHOOTING
In the USA, the MityCross 800 comes with a lifetime limited warranty on
the light housing and one year warranty on electrical parts, against any
defective part or craftsmanship. The battery is warranted up to 6 months
after the original date of purchase. If the unit is under warranty, Cygolite
will repair or replace defective components at no charge provided the
product has not been subject to misuse, abuse, or non-Cygolite authorized
alteration, modification or repair. Warranted products requiring service
must receive a Return Merchandise Authorization number (RMA#) from
customer service. The original receipt (INCLUDING DATE) is required on
all warranty repairs. Shipping costs inccurred from shipping warranty or
repair items from the customer to Cygolite are covered by the customer.
For warranty issues outside the USA, contact the retailer where the
purchase was made.
WARRANTY
WARRANTY
WARRANTY
WARRANTY
WARRANTY
CYGOLITE
1307-A EAST SAINT GERTRUDE PL., SANTA ANA, CA 92705 USA
PHONE: (714) 437-7752 FAX: (714) 437-7962
www.cygolite.com
All Cygolite products are backed by Cygolite’s warranty, providing
quality, craftsmanship, and the assistance of our knowledgeable staff.
If any support is needed, we will assist with 48 hour turnarounds on parts
and service. For questions, problems, and/or authorized Cygolite parts
contact us.
COMMITMENT
COMMITMENT
COMMITMENT
COMMITMENT
COMMITMENT
CONTENTS
• High-brightness LED headlight
• Rechargeable Li-Ion battery
• Smart Rapid charger
• Locktite Handlebar Bracket
• Helmet mount kit (Xtra model only)
• Operation Manual
Q: When should I charge my battery?
· The battery can be charged any time, but we recommend fully charging the battery
every time you charge it.
Q: Can I leave my battery on the charger for extended periods of time?
· The Smart Rapid charger prevents damage from overcharging but, like all electrical
appliances, we recommend unplugging the battery and charger once the battery is
fully charged.
Q: How do I know the charger is charging?
· When the Smart Rapid charger system is plugged into the wall outlet and connected to
the battery, the LED charging indicator on the charger will be RED, indicating it is in
Rapid charge mode. If the LED shows GREEN, the charger is in trickle mode and the
battery is fully charged.
Q: Will chargers for my other Cygolite systems recharge the MityCross 800 battery ?
· Yes, the chargers for any of the other MityCross models and the Explorer 650
will charge the MityCross 800 correctly.
Q: Can I use non-Cygolite parts for this unit?
· No, Cygolite parts are manufactured to specific quality specifications. Use of non-
Cygolite parts will void the warranty and may cause damage to the light.
QUESTIONS ABOUT CUSTOMIZING LIGHT SETTINGS
Q: What if I messed up my settings what should I do?
· You can get back into program mode and reprogram each programmable setting or you
can restore the light back to the factory default settings.
(see Restore factory default settings)
Q: How do I know I am in programming mode?
· The light will automatically scroll between the 4 programmable settings every 5
seconds, and the 3 LED indicators will illuminate to show which programmable
setting you are in.
Q: How do I know which programmable setting I am in?
· The indicator on the button will show what programmable setting you are in
(see CUSTOMIZE LIGHT SETTINGS)
Q: What happens if I am in programming mode and I don’t change any of the settings?
· The light will retain the original settings.
Q: When in programming mode, I am holding down the button but the brightness (or flash
speed) is not changing, why?
· The light reached the maximum or minumum endpoint. Simply release the button then
press and hold the button again, and the light will increase or decrease in brightness
(or flash speed) in the opposite direction.
Q: How do I know the light saved my programmed setting?
· If you set your preferred brightess level, did not press the button for 5 seconds, and the
light switched to the next programmable setting then the light saved that setting.
Q: What if I only program 1 of the programmable settings but not the others?
· The light will use the setting you chose for the that setting then use the original
settings for the other settings you did not program.
Q: While programming, if I skipped a programmable setting, how can I program the setting I
missed?
· During programmable mode the light will cycle through the programmable settings if
you don’t press the button, simply wait for the light to cycle back to the setting you
skipped, then program it.
Q: What if I don’t want to program the light, can I use it normally?
· Yes you can use the light with the factory default settings it came with.
Q: Are there a number of times I can change my programmable settings?
· You can change your programmable modes as many times as you wish.
