5
tighten screws until wood filler strips are secured under cabinet.
2.
Center the hood in place beneath the cabinet
and flush with the front of the cabinet.
3.
Mark the four keyhole mounting slots for the
hood. Mark these onto the bottom of the
cabinet; or, if the cabinet bottom is recessed,
onto the wood strips.
4.
Mark on the cabinet bottom or wall the
position of the access hole through which the
power supply cord is to be routed.
5.
Drill out the electrical power line
access hole as marked with a 1 ¼”
wood drill bit (Fig. 8).
Providing Electrical Power
6.
Screw the four hood mounting wood
screws into the center of the keyholes
(Fig. 9) marked on the cabinet bottom
(for flush installation) or the 1” x 2”
wood strips (for recessed cabinet
installation). Do not turn the mounting
screws in all the way to allow
adequate space for the hood to be
fitted into place.
7.
Place the range hood on the bottom of the cabinet. Route the power supply cord through the
access hole and through the knockout. This step will have to be accomplished while
positioning the hood (Fig. 10).
8.
Fit the four wider ends of the keyholes into the four screws on the cabinet, and then adjust
the hood until the screws are pushed into the narrow part of the keyhole slots. The front of
the hood should be flush with the cabinet front.
9.
Check to ensure the rear or top vent is fitted and connected to the duct properly.
10.
Tighten the hood mounting screws all the way into the cabinet or into the 1” x 2” wood strips
so the hood is firmly attached.
Making the Electrical Connection
11.
Secure the electrical connector to the hood with the connector’s “STAR” locknut.
12.
Strip about ½” of insulation from the ends of the electrical power wires.
13.
Connect the power line ground wire to the green ground wire supplied with the hood (Fig. 11)
14.
Connect the black power wire to the black wire supplied with the hood. Do the same with white
wire.
15.
Reinstall the hood cover plate with the insert screws.
16.
Attach the rectangular and round oil collectors at the far back and under the mesh
respectively.
Use and Care
17.
Light bulb: Slide light bulb access cover to expose the lamp-holder. Screw in a light bulb. Do not use round shape light
bulb for models CY1000 or CY1000R. Do not use more than 60W incandescent light for any model. Recommended use
of 23W florescent tube which is equivalent to a 90 W incandescent light bulb.
18.
Switches: The fan and light are each controlled by a rocker switch. The light switch has two positions, “ON” and “OFF”.
19.
The fan switch has three positions, “HIGH”, “LOW” and “OFF”.
20.
Cleaning: Clean the hood with a mild detergent suitable for painted surfaces. Do not use abrasive cloth, steel wool pads,
or scouring powders.
21.
Fan: The fan assembly is designed such that it will never need lubrication.
