© 2006-2011 ALL RIGHTS RESERVED.
18
TROUBLESHOOTING
ENGINE WON’T START
•
You should not see the Status LED flashing when you attempt to start
your bike’s engine. Be sure the 866F is disarmed and that you don’t have
the immobilizer enabled in Sleep mode. If you find your transmitter is
not working, Cyclone is likely in Sleep Mode (see pages 12-13).
•
Check your bike’s battery voltage. It could be too low to start the bike.
•
Keep in mind that water damage to Cyclone could prevent starting.
WORRIED TRANSMITTER BATTERY MAY DIE
•
You can disarm without a transmitter. See “Manual Disarming” on pg.11.
•
CR1616 batteries can usually be purchased at any convenience store.
SIREN SOUND NOT LOUD ENOUGH
This could be due to the mounting location. Some bikes offer more
insulation inside the under-seat compartment that others, which may
decrease the sound level.
WHAT FUNCTIONS WORK IN WHAT MODE?
(See
Table-3 below.)
TABLE-3
866F FUNCTIONS VS. MODE
Function
Normal Mode
Silent Mode
Sleep Mode
Immobilizer
a
a
Enable/Disable
Panic Siren
a
Tilt Sensor
a
a
Shock Sensor
a
a
Ignition Sensor
a
a
Listen to Tx for 20s
Transmitter Operation
a
a
20s from IG on
Status LED
a
a
If Immob. Enabled
Warning Chirps
a
Full Siren Blast
a
Confirmation Chirps
a
a
20s from IG on
Sleep Mode ON/OFF
a
a
a
Silent Mode ON/OFF
a
a
Transmitter Learning
a
a
