12
13
Charging the Battery
The Cyclevision Helmet comes fully assembled with an internal 3250mA
Lithium Polymer Battery.
The Battery is fully enclosed in its own separate housing and is not
removable from the Cyclevision Helmet. Do not attempt to open the
Helmet to change the battery under any circumstances. The battery
housing has been sealed therefore damage to the housing, camera
and PCB may occur if tampered with. Any attempt to open the camera
housing will result in voiding of the warranty.
To charge the Cyclevision Helmet plug one end of the USB cable
into any wall power outlet, we recommend a DC5V - 2A USB charger
adapter, and place the other end of the Micro USB cable into the
REAR
Micro USB Port.
Do not
plug power into the front USB port – this will not result in battery
recharge and may damage the electronics.
Step 5 - Final Check
The Cyclevision Helmet must be properly secured on the head without
rocking forward over the eyes and/or backward on the head.
This does not only provide correct protection in case of a crash but is
necessary for the quality of the video recording. Both the front and rear
camera angles are preset for correct helmet positioning.
Cyclevision cannot be held responsible for vision data capture angle
differences if the Helmet is not correctly placed and secured on the head.
SETTING UP CYCLEVISION HELMET
CHARGING CYCLEVISION HELMET
