Finish attaching the bottom fabric. Secure the bottom fabric to the frame on each side, opening the Velcro and rolling it over the
top of the side rails of the frame. The bottom fabric has Velcro loops that need to be attached around the bottom of frame’s
sides.
The canopy top now attaches with the Velcro to the sides of bottom fabric.
Back Cover, Front Mesh and Front Vinyl Rain Guard
Back cover: Start at the top center-back of the canopy top and attach the center of the back cover to the canopy top. From
the center, work your way down on both sides until the fabric lines up evenly and reaches the Velcro on the fabric bottom.
Front Mesh: Start at the center-front of the canopy top and attach the front mesh to the canopy top. From the center, work
your way down on both sides until the fabric lines up evenly and reaches the Velcro on the front of the fabric bottom.
Vinyl Rain Guard; The vinyl rain guard fits over the front mesh and will only attach to the mesh, not to the canopy top.
Wheels
NOTE: If you have a braking system, skip this section, go to the separately enclosed Braking System Instructions, and then return
to Wheel Reflectors.
If the Wheel’s Quick Release Skewers are separate from the wheels ,unscrew the nut and remove one spring. Then slide the
skewer through the axle of the hub (center of the wheel). Replace the spring with the smaller end towards the inside, and loosely
attach the nut.
Set the wheel into the dropouts of the
frame with the quick release lever to the
outside of the trailer.
Tighten the nut until the
quick release lever can be
closed tightly (press lever
in, not around in a circle).
The wheels should be very secure in the drop outs.
Wheel Reflectors
If not pre-installed, Install the wheel reflectors into the wheels with
enough space from the tube valve to add air easily to the tires.
Tow bar
Insert the two red set screws (wing nuts) into the threaded holes in the main frame
just far enough to hold them in place. Slide the tow bar downwards, between the
main frame and the two notched front struts.
There are two grooves in the tow bar. Select the grooves that allow your trailer to sit
closest to level. Adjust the tow bar while you tighten the red set screws by hand so
that the screw tips fit into the indentations in the front of the tow bar.
When tightened securely, the tow bar is pressed firmly against the struts to prevent
it from loosening.
Jogger Stroller
If you are installing the Jogger wheel, instead of the tow bar, follow Jogger Stroller
instructions which are a included separately, then return to Rear Reflector.
RING
Red Set Screw
Grooved strut
under fabric
Grooved strut
Skewer
2
Drop Out
Press Lever
