Cycle Torch Night Owl 200, Руководство пользователя

Страница: 6 / 9

NIGHT OWL 200 USER MANUAL
6
Switching lighting modes
OPERATION MODES
The initial short press of the power button will
turn the light on High mode. Each additional short
press of the power button switches the light from
one mode to the next in the following order:
1 High
2 Medium
3 Low
4 Flash
TURNING OFF NIGHT OWL 200
Press and hold the button for one
to three seconds.
CHECKING BATTERY LEVEL
When the light is turned off, press the button for
3 seconds and release. The light will flash from
1 to 10 times indicating the battery level remain-
ing (10 flashes indicate - 100% charge, 9 flashes
- 90%, 8 flashes – 80% …).
LOW BATTERY LEVEL
Night Owl 200 will automatically turn off when
the battery level is too low. This system protects
the battery from damage, but since it draws a
small amount of current, and can drain the
battery beyond the minimum voltage for the
battery.
It is strongly recommended to recharge Night Owl 200 when there is less than
20% load (see: checking battery level). Do not wait until the light goes
completely out as this will greatly reduce the number of charge cycles that the
battery can be used and can render the battery unusable.
Charge your bike light every 2-3 months when stored or not in use to prevent
battery degradation.
Operating modes: High Medium Low Flash
Run time (in hours) 2 4 20 40
Power (in lumens) 200 100 20 200
NIGHT OWL 200 HEADLIGHT
4