CYBEX Eagle 11181, Руководство пользователя

Страница: 19 / 32

Cybex Eagle 11181 Hip Abduction/Adduction Owner’s Manual
Assembly
Page 4-3
Using an external snap ring pliers, remove the upper C.
snap ring from one of the guide rods and carefully lower
the guide rod. See Figure 6.
Remove lower snap ring and wave washer from the D.
guide rod. Repeat steps 6C and 6D to remove both
snap rings from other guide rod.
If possible, lean guide rods outward, away from machine E.
in
order to provide the most room for installing weight plates.
Slide top weight up and out of machine and carefully set it aside. F.
Wipe guide rods clean over entire length. Lubricate with light coating of medium weight automotive engine oil. G.
Carefully install each weight plate one at a time. H. NOTE: When installing weight plates, position plates so wide
edges of bushing face upward and narrow edges of bushing face downward. See Figures 7A and 7B.
Slide top weight onto guide rods. I.
Place lower snap ring and wave washer onto guide rod J.
(about 3” from the top end of guide rod).
Raise guide rod up through mounting hole and install K.
the upper snap ring.
Lower guide rod and secure lower snap ring. Repeat L.
steps 6J - 6L for the other guide rod.
Reinstall the six increment weights that were removed M.
in step 6B. See Figure 8.
Turn the Increment Weight Adjusting Knob to select all N.
15 lbs.
7. Install back shrouds/route weight stack belt
Carefully place shroud back into position on the two A.
bottom screws. See Figure 9.
Figure 9
Screw
Figure 8
NARROW
bushing edge
WRONG
WIDE bushing
edge faces
upward
CORRECT
NOTE: The narrow bushing
edge must face downward.
Figure 7A Figure 7B
Figure 6
Upper snap ring
Lower snap ring
Frame
Guide rod
Wave washer
WRONG
CORRECT
Increment
Weights