CYBEX Eagle 11111, Руководство владельца и по обслуживанию

Страница: 20 / 42

Cybex Eagle 11111 Fly/Rear Delt Owner’s Manual
Assembly
Page 4-4
Slide belt through slot in belt clamp. C.
Verify belt and insert are installed properly, as shown D.
in Figure 9A. NOTE: Do not install the insert backwards
as shown in Figure 9B.
Pull belt tight and secure belt to clamp with the two E.
set screws. NOTE: Torque set screws 300-350 in./lbs.
See Figure 10.
Place weight stack pin in each plate to verify proper F.
installation.
Without selecting any resistance, lift top weight G.
up and down (simulating normal operation).
Have an assistant verify that the belt is moving smoothly and H.
is routed straight from the top pulley bracket to the
top weight belt clamp.
Reinstall the six increment weights that were removed I.
in step 6B. See Figure 11.
Turn the Increment Weight Adjusting Kob to select all J.
15 lbs.
8. Install back shrouds.
Carefully place shroud assembly back into position on A.
the two bottom screws. See Figure 12.
Install the top two screws securing the back shroud B.
assembly. See Figure 13.
Figure 13
Screw
Figure 12
Screw
Figure 11
Grooves
Increment Weights
Correct belt routing Wrong belt routing
Stem
Belt
Insert
Stem
Belt
Insert
Figure 10
Belt clamp
Belt
Belt clamp
insert
Set screws
Figure 9B Figure 9A