CPS700AVR
Guaranteed Uninterruptible Power System
As the battery discharges, the unit will beep more rapidly, indicating that the battery is nearing discharge. Once the test is complete, plug the UPS back in to
the AC outlet and start your computer. Please allow 4 hours for the UPS to recharge before attempting another self-test.
DEFINITIONS FOR ILLUMINATED LED INDICATORS
Power
On/AVR
Wiring
Fault
Using
Battery
Circuit Breaker
Alarm
Condition
On Off
Off
Set
Off
Normal
Flash
Quickly
On/Off Off
Set
Off
AVR-
AVR is maintaining a consistent 120v level (±5%)
during a power sag.
Flash Slowly
On/Off
Off
Set
Off
AVR-
AVR is maintaining a consistent 120v (±5%)
during a power surge
Off On/Off
On
Set
Two
Beeps
Utility Failure-
The UPS is providing battery power to the Battery-Power
Supplied outlets.
Off On/Off
On
Set
Rapid
Beeps
Utility Failure-
The UPS is providing battery power. The rapid beeps indicate
the battery will run out of charge within a few minutes.
Off Off
On
Up
Two
beeps
or
rapid beeps
Overload-
Occurs in the
Full-time Surge Protection Outlets
. Turn the UPS
off and unplug at least one piece of equipment from the UPS. Wait 5 seconds,
reset the circuit breaker and turn the UPS on.
On/Off/Flash On/Off
On
Set
Long
Beep
Overload-
Occurs in the
Battery-power Supplied Outlets
. Turn the UPS off
and unplug at least one piece of equipment from the UPS. Wait 5 seconds,
reset the circuit breaker and turn the UPS on.
Off Off
On
Up
Long
Beep
Overload-
Occurs in the
Battery-power Supplied Outlets
. Turn the UPS off
and unplug at least one piece of equipment from the UPS. Wait 5 seconds,
reset the circuit breaker and turn the UPS on.
On/Flash On/Off Flash
Set
None
Weak Battery-
Recharge the battery for at least 8 hours. If
Check Battery
is
illuminated contact CyberPower Systems for battery replacement information.
Flash On/Off
Flash
Set/Up
Off
Scheduled Turn-on-
If the two battery indicators are flashing in rotation, the
UPS is waiting to turn on as configured in the schedule.
Flash On/Off
Flash
Set/Up
Three
Beeps
Cold Start Disabled-
If the two battery indicators are flashing at the same
time, the cold-start has been disabled. The UPS will not start in the absence
of AC power.
On/Off On
On/Off Set/Up
None
Electrical Wiring Fault-
This indicates a wiring a problem such as a bad
ground, missed ground or reversed wiring
within the AC outlet
. User is
advised to disconnect all electrical equipment from the outlet and have the
outlet checked by an electrician.
7