CyberOptics SE505, Руководство по оборудованию

Страница: 44 / 180

Chapter 3 : Installation
34 SE505 Hardware Manual
Installing the System
Installing the SE505 system consists of the general steps listed below. Each step is described in
more detail on the following pages.
●
“ Installing the Light Pole ” on page 34
●
“ Positioning / Leveling the SE505 System ” on page 35
●
“ Installing the Sensor ” on page 39
Installing the Light Pole
➢
To install the light pole
1. Loosen and remove two spring loaders along the upper rear panel to remove the panel from
the system.
2. Remove the attaching nut from the light pole and slide it off of the cable.
3. Place the light pole in an upright position and insert the threaded end of the pole into the
hole on top of the enclosure.
4. Tighten the bolt inside the enclosure so that the light pole is firmly attached to the unit.
5. Connect the light pole cable to the available cable connector that is tied to the frame.
6. Replace the rear panel.
Figure 29. Light Pole Installation
Caution:
The SE505 is a precision measurement system. To ensure optimum performance of
your SE505, a trained CyberOptics service representative is required to install the system.
Slide nut onto cable and
tighten underneath frame
Connect light pole cable to
cable inside frame