Cybernet H6 i-One Series, Руководство пользователя

Страница: 21 / 30

Cybernet i-One H6/H7 System Assembly
Page 14
Installing the CPU
NOTE: If you purchased your iOne as a turn-key system, you must first follow the
instructions to remove the heat sink in order to be able to reach the CPU. Systems
purchased as ‘bare bones’ require the installation of the heat sink which is shipped in the
accessories box with the unit.
1. The socket has a plastic cap on it to protect
the pins from damage. This should remain
in place until actually installing a CPU.
2. Raise the plastic cap to reveal the socket
pins and open the cover by pushing down,
pulling out and up on the lever beside the
CPU socket.
Note: Do not touch the socket pins to avoid
damage.
3. Install the CPU after confirming the direction
for correct mating. Be sure to hold the CPU
by the edge of the CPU base.
Note: The CPU can only be installed in the correct
direction. Make sure the CPU pins are completely
embedded into the socket. If not, take out the CPU
with vertical motion and reinstall.
4. Close the cover and the lever to complete
installation. Replace the heat sink.
NOTE: Any violation of the correct installation procedures may cause permanent
damage to your motherboard.