Quick Reference
931350C
© 2020, CyberData Corporation, ALL RIGHTS RESERVED
© 2020, CyberData Corporation, ALL RIGHTS RESERVED
931350C
Quick Reference
Getting Started
Take the following into consideration before you install this product:
•
When this secure phone case is used, the touch screen capability of the DX phone is disabled.
•
Due to the size and mass of this product, it is important that the Backbox is safely installed according to these installation
instructions.
•
Make sure that the type of wall is capable of supporting the system and use screws that are suitable for that type of wall.
•
The system must be installed by qualified personnel in accordance with state and local building regulations.
•
Also see the
Install the DX70 Phone to Enclosure
(on the other page).
•
Locate the provided Security Torx Driver Bit (usually taped right next to the Hookswitch on the Faceplate).
•
Tool required to remove Security Torx Screws (an Electric Hand Drill or Powered Screwdriver)
•
WARNING: To prevent injury, this apparatus must be securely attached to the floor/wall in accordance with the installation
instructions.
•
WARNING: The PoE connector is intended for intra-building connections only and does not route to the outside plant.
•
WARNING: This enclosure is not rated for any AC voltages!
Hookswitch Wires to USB to Analog Audio Module Connections
Contacting CyberData
Black Wire
to Terminal
Black Wires
1
10
USB-B
Black Wire to Terminal
Green Wire to Terminal
Yellow Wire to Terminal
Red Wire to Termianl
Terminal
Audio Module
USB to Analog
Block
Armored Cord
Armored Cord
Handset Retainer
Factory Disconnected
to Terminal 5
Red Wire
Connections
Reconnect Before Fasten Faceplate Assembly to Backbox
Connector
Receptacle
Connector
Plug
Magnetic Hookswitch
Backbox
***
***
Connections
Armored Cord Handset
9
4
3
2
1
USB-A
Phone
Cable Connections
USB-B to USB-A
Sales: 831-373-2601 ext. 334
Support: 831-373-2601 ext. 333
Support Website:
RMA Department: 831-373-2601 ext. 136
RMA Email: [email protected]
RMA Status:
Warranty Information:
http://support.cyberdata.net/
Corporate Headquarters
CyberData Corporation
3 Justin Court
Monterey, CA 93940, USA
Phone: 831-373-2601
Fax: 831-373-4193
Backbox Mounting
Install a Shunt on JP2 to Enable Auto Answer Mode
Dimensions are in Inches [Millimeter]
Conduit Hole Ø 1.3 [Ø33] Fits 1" EMT Fittings
Ø1.3 [Ø33]
Conduit Hole
1.969 [50.0]
4.026 [102.3]
6.212 [157.8]
1.969 [50.0]
2.362 [60.0]
14.173 [360.0]
17.717 [450.0]
2.165 [55.0]
19.685 [500.0]
13.386 [340.0]
6.496 [165.0]
Ø0.41 [Ø10.5]
Last Updated 08/06/2020
View Shown with Hole Plug Installed.
Open Faceplate then Remove Nut from the Inside.
11/32" or 9mm Socket & Socket Wrench
Tool Required to Remove Hole Plug:
JP2
Shunt
The IP Endpoint Company
Installation Quick Reference
DX70 Secure Phone
011388
