Operations Guide
931475A
CyberData Corporation
Installing the SIP Weatherproof Keypad Phone
Setting up the Device
27
2. On the
Device
page, you may enter values for the parameters indicated in
Note
The question mark icon (
) in the following table shows which web page items will be defined
after the
Toggle Help
button is pressed
.
Table 2-5. Device Configuration Parameters
Web Page Item
Description
Volume Settings (0-9)
Handset Volume
Default volume level of the Handset Speaker (0-9). This is the volume that
will be set when a call is established. The volume can be adjusted in-call
by using the buttons on the handset
Handset Mic Gain
The gain level of the Handset Microphone (0-2).
Ring Volume
Set the ring volume for incoming calls (0-9).
Clock Settings
Set Time with NTP Server on boot
When selected, the time is set with an external NTP server when the
device restarts.
NTP Server
Use this field to set the address (in IPv4 dotted decimal notation or as a
canonical name) for the NTP Server. This field can accept canonical
names of up to 64 characters in length.
Note
: The
setting needs to be restarted to spawn NTP or to
change the server.
Posix Timezone String
See
Section 2.3.11.1, "Time Zone Strings"
for information about how to
use the Posix Timezone String to specify time zone and daylight savings
time where applicable. Enter up to 63 characters.
Periodically sync time with server
When selected, the time is periodically updated with the NTP server at the
configured interval below.
Time update period (in hours)
The time interval after which the device will contact the NTP server to
update the time. Enter up to 4 digits.
Note
: Syncing and changing the
setting
does not require a reboot for the changes to take effect.
Current Time
Allows you to input the current time. (6 character limit)
Relay Settings
Note
: None of the
require a reboot for the changes to take
effect.
Activate Relay with DTMF Code
Activates the relay when the DTMF Activation Code is entered on the
phone during a SIP call with the device. RFC2833 DTMF payload types
are supported.
Relay Pulse Code
DTMF code used to pulse the relay when entered on a phone during a SIP
call with the device. Relay will activate for Relay Pulse Duration seconds
then deactivate. Activate Relay with DTMF Code must be enabled. Enter
up to 25 digits (* and # are supported).
Relay Pulse Duration (in seconds)
The length of time (in seconds) during which the relay will be activated
when the DTMF Relay Activation Code is detected. Enter up to 5 digits.
Activate Relay During Ring
When selected, the relay will be activated for as long as the device is
ringing. When Auto-Answer Incoming Calls is enabled, the device will not
ring and this option does nothing.
Activate Relay During Night Ring
When selected, the relay will be activated as long as the Nightringer
extension is ringing.