CyberData 011433, Руководство по эксплуатации, Страница: 60 / 98

Operations Guide 931384A CyberData Corporation
Installing the Secure Access Control Keypad
Secure Access Control Keypad Setup
53
2.4.11 Configure the Events Parameters
The Events page specifies a remote server that can be used to receive HTTP POST events when
actions take place on the board.
1. Click on the Events menu button to open the Events page ( Figure 2-26 ).
Figure 2-26. Event Configuration Page
2. On the Events page, enter values for the parameters indicated in Table 2-18 .
Note The question mark icon ( ) in the following table shows which web page items will be defined
after the Toggle Help button is pressed
.
CyberData Security Keypad
Table 2-18. Events Configuration Parameters
Web Page Item Description
Enable Event Generation The device will send HTTP POST events to the specified remote server and port
number whenever a certain action takes place. Select an event type below to
generate an HTTP POST event.
Events
Enable Call Start Events When selected, the device will report the start of a SIP call.
Enable Call Terminated Events When selected, the device will report the end of a SIP call.
Enable Relay Activated Events When selected, the device will report relay activation.