CyberData 011433, Руководство по эксплуатации, Страница: 41 / 98

Operations Guide 931384A CyberData Corporation
Installing the Secure Access Control Keypad
Secure Access Control Keypad Setup
34
2. On the Security page, you may enter values for the parameters indicated in Table 2-12 .
Note The question mark icon ( ) in the following table shows which web page items will be defined
after the Toggle Help button is pressed
.
Table 2-12. Security Configuration Parameters
Web Page Item Description
Security Configuration (Record)
Name Displays the name associated with this security record.
Code Displays the security code associated with this security record.
Valid From See Section 2.4.6.2, "The “Valid From” and “Valid To” Settings" .
Valid To See Section 2.4.6.2, "The “Valid From” and “Valid To” Settings" .
Blacklist Displays the Blacklisted status of this security record. Blacklist is used to
deny entry to the specified security code. Entering a blacklisted code will
trigger the buzzer, and can trigger a call to an extension or a multicast of
a pre-recorded message.
Opens the Configure Security Code Page . See Section 2.4.6.1,
"Configure the Security Code Page" .
Removes the security code record.
Opens a new Configure Security Code window.
Relay Settings
Activate Relay on Valid Entry Activates the relay when a valid code is entered. This would likely be
used to open a door.
Activate DSR on Valid Entry Activates the remote relay when a valid code is entered. This would likely
be used to open a door.
Relay Timeout (seconds) Specifies how many seconds the relay will be activated after a valid code
entry. In a typical use case, this would specify how long the door is
unlocked.
Buzzer Settings Note: The buzzer LED remains red when the door is locked, flashes
green when a valid code is entered, and flashes red when an invalid
or blacklisted code is entered.
Buzz while Relay Active When selected, an audible buzz will indicate the relay is active.
The buzzer LED remains red when the door is locked, flashes green
when a valid code is entered, and flashes red when an invalid or
blacklisted code is entered.
Buzz on Invalid Code Entry When selected, a pattern will play on the buzzer to indicate an invalid
code was entered.
Buzz on Keypad Button Press When selected, an audible buzz will play to indicate that a button has
been pressed.
Sensor Settings
Buzz on Door Open Timeout When selected, the buzzer will beep until the on board sensor is
deactivated.