Operations Guide
931384A
CyberData Corporation
Installing the Secure Access Control Keypad
Secure Access Control Keypad Setup
28
2. On the
Device
page, you may enter values for the parameters indicated in
Note
The question mark icon (
) in the following table shows which web page items will be defined
after the
Toggle Help
button is pressed
.
Table 2-7. Device Configuration Parameters
Web Page Item
Description
Clock Settings
Set Time with NTP Server on boot
When selected, the time is set with an external NTP
server when the device restarts.
NTP Server
Use this field to set the address (in IPv4 dotted decimal
notation or as a canonical name) for the NTP Server. This
field can accept canonical names of up to 64 characters in
length.
Posix Timezone String
Section 2.4.5.1, "Time Zone Strings"
for information
about how to use the Posix Timezone String to specify
time zone and daylight savings time where applicable.
Enter up to 63 characters.
Periodically sync time with server
When selected, the time is periodically updated with the
NTP server at the configured interval below.
Time update period (in hours)
The time interval after which the device will contact the
NTP server to update the time. Enter up to 4 digits.
Current Time
Allows you to input the current time. (6 character limit)
Relay Settings
Activate Relay with DTMF Code
Activates the relay when the DTMF Activation Code is
entered on the phone during a SIP call with the device.
RFC2833 DTMF payload types are supported.
Relay Pulse Code
DTMF code used to pulse the relay when entered on a
phone during a SIP call with the device. Relay will activate
for Relay Pulse Duration seconds then deactivate.
Activate Relay with DTMF Code must be enabled. Enter
up to 25 digits (* and # are supported).
Relay Pulse Duration (in seconds)
The length of time (in seconds) during which the relay will
be activated when the DTMF Relay Activation Code is
detected. Enter up to 5 digits.
Relay Activation Code
Activation code used to activate the relay when entered on
a phone during a SIP call with the device. Relay will be
active indefinitely, or until the DTMF Relay Deactivation
code is entered. Activate Relay with DTMF Code must be
enabled. Enter up to 25 digits (* and # are supported).
Relay Deactivation Code
Code used to deactivate the relay when entered on a
phone during a SIP call with the device. Activate Relay
with DTMF Code must be enabled. Enter up to 25 digits (*
and # are supported).
Misc Settings
Device Name
Type the device name. Enter up to 25 characters.
Keypad Brightness (0-255)
The desired keypad brightness level. Acceptable values
are 0-255, where 0 is the dimmest and 255 is the
brightest. Enter up to three digits.