CVS DA-220, Инструкция по эксплуатации, Страница: 4 / 8

P.O. Box 749 Peekskill, NY 10566 Tel: (845) 737-7009 Fax: (845) 737-0426 Web: www.compuvideosystems.com
Installing a Board Set in an open slot:
A) Holding the board so that the components face up, carefully slide the board into the
slot. Seat the board in the mating connector in the motherboard. If you meet any
resistance, remove the board and check for bent pins and a misaligned mating
connector in the back of the slot. After correcting the error, reinstall the board. Then
for long boards (Fig.1) reinstall both screws that hold the board in place.
B) On the rear of the unit you need to install the connector field. Carefully align the top pin
on the back of the connector field with the top pin on the internal connector on the rear
of the chassis. There may be open slots on the connector in the chassis. After the
connector panel is installed, using a small Philips head screwdriver, install the two
mounting screws in the panel.
C) Once the boards have been removed/installed you can reconnect the video cables.
D) Attach a test monitor the recently installed BS and test for proper operation. Check
for video. If none is present, check the installation of the rear connector field for a
misalignment. Reset the rear connector panel and test again. Align the board as
specified.
E) For Short Boards (Fig 1), once the board has been adjusted, Install the blank front
panel on the CH-1 with the 2 small screws. Then reinstall chassis cover.
If any problems persist, call 845-737-7009 and ask for tech support.
Fig. 2
Standard Rear View