P.O. Box 749 Peekskill, NY 10566 Tel: (845) 737-7009 Fax: (845) 737-0426 Web: www.compuvideosystems.com
While the CDA-211-RJ45 has rubber feet for table top use, it can be wall mounted by
simply using the cover side flange mounting holes. (4) #8 screws are recommended for
mounting.
Installation And Removal Of A Board Set
(BS) From The CH-1 Chassis.
1) Remove power from the system by unplugging the power pack from the power
source.
2) Remove the 2 screws holding the top cover on the chassis.
Removal of a BS:
A) Remove the 2 screws holding the front panel in place. For Short boards remove the
screw from the side of the card guide. Then unplug the board by gently pulling the
board towards the front of the chassis. Long Boards have the front panel attached to
the board, while short boards have a separate, blank front panel.
B) On the rear of the unit the connector board that must be removed if a complete boards
set is being changed. As there are no electronics on the rear board you do not need
to change it for repair purposes. Using a small Phillips head screwdriver, remove the
top and bottom screw from the connector panel. Carefully, holding on to a connector,
pull the panel away from the rear of the chassis. Put the main board and the connector
board together.
Fig. 1
Front View
Model
# Of Inputs # Of Outputs
Controls
Special Features
CDA-211-RJ45
2
2 Per Input
Gain & HF
Adjustments
Ground Loop
Protection
Содержание CDA-211-RJ45
Страница 8: ......