SMART TRIPLE PLAY® Run Brake Turn Controller with
Built in Strobe/Flasher (Patent Pending)
5. Initial Setup and Operation: Locate the two switches and rotary dial. Be sure the rotary
dial is set to position 0. Note there is a screw diver slot to make the dial turn easer, this
is not the pointer, there is small arrow on the dial , this is the pointer that should now be
at position 0. Be sure Switch 1 and Switch 2 are both in the ON position.
6. Turn the ignition key on and check operation as follows:
•
Running Lights: Turn Signals and Taillight are now illuminated dimly.
•
Apply Right Turn Signal and check operation of right turn signal, should flash off to
bright. Disable turn.
•
Apply Left Turn Signal and check operation of left run signal, should flash off to bright.
Disable turn.
•
Apply Brake Light. Check to see that all 3 lights flash 4 times then remain bright.
•
Apply Left Turn Signal then Apply Brake, Check to see that Only Center Light
Flashes 4 times then remains bright.
Installation Instructions
Off Off
On On
1
2
Rotary
