Installation Instructions
-
Page 2
Questions? Call us at: 1 (800) 382
-
1388 M
-
TH 8:30AM
-
5:30PM / FR 9:30AM
-
5:30PM EST
12
-
2017
Off
Off
On
On
1
2
Rotary
Diagram
-
Module Controls
•
Running Lights: BAGZ
™
Lights are now illuminated dimly.
•
Apply Right turn signal and check operation of right turn signal, should
flash off to bright. Disable turn.
•
Apply Left turn signal and check operation of left turn signal, should flash
off to bright. Disable turn.
•
Apply brake light. Check to see that all lights flash 4 times then remain
bright.
•
Apply Left turn signal then apply brake. Check to see that only center light
flashes 4 times then remains bright. If no center tail light is applicable,
when the left turn signal is on and the brake is applied, the right side turn
signal will stop strobing. This is normal operation.
1.
The Smart Triple Play® allows you to program the running light brightness of the BAGZ
™
Lights so they are a match to your taillights. To en-
ter the modules program mode:
Program Mode:
•
Turn ignition key off, be sure Switch 1 and Switch 2 are in the OFF position and the rotary dial in in the 0 position.
•
Turn ignition key on, immediately turn Switch 2 On
-
Off
-
On. Turn Switch 1 On
-
Off
-
On. Do not depress Brake or Turns Signals
during this action.
•
The turn signals should now fade up and down slowly, do not proceed unless this confirmation takes place.
•
Turn the rotary dial clockwise to increase the brightness of the running lights, 0
-
being the dimmest setting and 9
-
being the bright-
est. Match the running light brightness to the taillight. Once happy with the setting, press and hold the brake for a couple of sec-
onds. The setting will now be saved.
2.
Turn ignition key OFF and set switches for desired Operation.
Program Menu:
Switch Functions
:
Switch 1 On, Switch 2 On: Strobes/Flashes on all three Rear Lights
Switch 1 On, Switch 2 Off: Strobes/Flashes on rear turn signals only
Switch 1 Off, Switch 2 On: Strobes/Flashes on center light only
Switch 1 Off, Switch 2 Off: No Strobes/Flashes
1.
Locate the two switches and rotary dial on the Smart Triple Play® module. Be sure the
rotary dial is set to position 0. There is a small arrow on the rotary dial, this is the pointer
that should now be at position 0. Be sure Switch 1 and Switch 2 are both in the ON posi-
tion.
2.
Turn the ignition key on and check operation as follows:
Testing for Proper Operation:
