Installation Instructions
-
Page 2
Questions? Call us at: 1 (800) 382
-
1388 M
-
TH 8:30AM
-
5:30PM / FR 9:30AM
-
5:30PM EST
07/2018
F
E
C
F
C
H
G
F
7.
Align the Rear Support Plate to the inside of the fairing
(See Figure D) to use as a template for drilling mounting
holes.
8.
Drill the two
1/4”
mounting holes. (See Figure E)
9.
Install provided plastic clip to retainer tabs on the Front
Support Plate (See Figure F)
10.
Re
-
align the Rear Support Plate to the inside of the fair-
ing. At the same time align the Front Mounting Plate to
the outside of the fairing.
11.
Secure both the Front Mounting Plate and the Rear Sup-
port Plate with supplied mounting bolts and nuts. (See
Figure G)
12.
Using a Dremel, grind down any parts of the fairing that
extrude on either side of the support plate. Both sides
must be flush with support plate to prevent the head-
lamps from hitting the fairing. (See Figure H)
13.
Align 3 mounting clips on your new ProBEAM® head-
lamp to the fairing and snap the headlamp assembly into
place.
14.
Bring the fairing with ProBEAM® headlamp to the bike.
Plug the H4 connectors to the new ProBEAM® head-
lamp (the red wire is for European use only).
15.
Hang fairing on the 2 mounting clips located on the inner
fairing.
16.
Re
-
install all fairing bolts.
17.
Reconnect the vehicle battery negative [
-
]
18.
Test all functions of both ProBEAM® Headlights to en-
sure they are working 100%
19.
Adjust headlamp if needed to maximize light output.
20.
Reinstall the OEM plastic headlamp cover.
D
E