Installation Instructions
-
Page 2
Questions? Call us at: 1 (800) 382
-
1388 M
-
TH 8:30AM
-
5:30PM / FR 9:30AM
-
5:30PM EST
05/2020
Instructions Continued:
6.
Plug the 2 pin turn signal plugs from
new taillight into the same connectors,
brown is right turn, purple is left turn.
Make sure they lock in place. (See fig-
ure 1)
7.
If you are continuing to use the stock
turn signals, plug the them into the 2 pin
connectors on the tail light. Brown is
right, purple is left. Make sure they lock
in place.
(See figure 2)
8.
Tuck connectors into the center space in
the center of the base. Make sure there
is enough space to allow installation of
the taillight.
(See Figure 3)
9.
Fit the new ProBEAM® LED taillight into
the taillight base, insert right Phillips
head screw, with nylon washer, and
tighten 1 turn. Insert left Phillips head
screw, with nylon washer, and tighten 1
turn.
10.
To ensure proper fit, take top of
ProBEAM® LED taillight and tip it down-
ward so that the top of the taillight as-
sembly goes under the lip of the taillight
base. While holding in this position,
tighten both left and right screws equally
until taillight is fully seated and screws
are snug.
DO NOT OVERTIGHTEN
!
Overtightening screws will crack the
lens at the screw holes and void warran-
ty.
11.
Check Operation of taillight in run, turn,
and brake modes.
Figure 1: 2 Pin Turn Connectors
Figure 2: Plugging in Stock Turns
Figure 3: Tuck wiring connectors
