Custom Audio Electronics TFTCM112II, Руководство пользователя

Страница: 15 / 48

2.3 Confi guration
During power-up, if both the LF LINE FEED and FF FORM FEED keys are held down, the printer enters con fi gura-
tion mode and prints-out the SETUP report. It will remain in standby until a key is pressed or characters are received
through the communication port (see Hexadecimal dump).
When the FF FORM FEED key is pressed, the printer enters the parameter entry mode. Press the FF FORM FEED
key to change the value or the LF LINE FEED to skip to the next parameter. After the last parameter another SETUP
report is printed.
This printer permits the con fi guration of default parameters. The printer’s con fi gurable parameters are:
Printer emulation: •
ESC/POS™, CUSTOM TPT
D
.
Baud Rate • (1) :
1200, 2400, 4800, 9600
D
, 19200, 38400, 57600.
Data length • (1) :
7, 8
D
bits/car.
Parity • (1) :
None
D
, Even or Odd.
Handshaking • (1) :
XON/XOFF
D
, Hardware.
USB Address Number • (2) (3) :
0
D
, 1, 2, 3, 4, 5, 6, 7, 8, 9.
USB Status Monitor • (2) (4) :
Disabled
D
, Enabled.
Autofeed: •
CR disabled
D
, CR enabled.
Panel Key: •
Disabled, Enabled
D
.
Print Mode: •
Normal
D
, Reverse.
Height Mode: •
x1
D
, x2, x4.
Width Mode: •
x1
D
, x2, x4.
Justifi cation: •
Left
D
, center, right.
With CUSTOM TPT • Font dimension (5) :
8x16 104 col, 16x24 52 col
D
, 24x32 34col.
With ESC/POS™ • Chars/line (6) :
A=58/B=80 col
D
, A=80/B=104 col.
Speed/Quality: •
Normal
D
, Draft or High Speed.
Current: •
Normal
D
, High or Low.
Paper Autoload: •
Disabled, Enabled
D
.
Reset Buffer: •
At Paper End
D
, No.
Print density: •
Normal
D
, Very Light, Light, Very Dark, Dark.
The settings made are stored in EEPROM (nonvolatile memory).
General Note:
The parameters marked with the symbol
D
are the default values.
Note (1) :
This parameter is displayed if the serial cable is plugged.
Note (2) :
This parameter is displayed if the USB cable is plugged.
Note (3) :
This parameter used to identify univocally the USB printer by a numerical address code, if on the
PC are connected two printers that are the same models for example two TPTCM112II.
Note (4) :
The Status Monitor is an additional printing driver component that allows the printer status monitor-
ing. It must be enabled only if it was installed the Status Monitor speci
fi c driver.
Note (5) :
This parameter is displayed only if
Printer emulation:
CUSTOM TPT.
Note (6) :
This parameter is displayed only if
Printer emulation:
ESC/POS™.
2. INSTALLATION AND USE
User Manual
TPTCM112II 15