Custom Audio Electronics STIMARE STIMA-SML, Руководство пользователя

Страница: 78 / 86

10.4 Printing area
In order to print ticket containing only one notch and to not overlay printing to a notch (that will make it useless for the next
alignment), it is important to well calibrate the length of the printing area of ticket according to the inter-notch distance.
The following igure shows an example of tickets with “Notch Distance” set to 0:
1 mm 1 mm
L
D H
PRINTED
AREA
PRINTING DIRECTION
Line of manual
tear off Printing line
Line of manual
tear off Printing line
H Distance between the irst and the last print line, called “Height of the printing area”.
L Distance between an edge of the notch and the next one, called “Inter-notch distance”.
D Automatic feed for alignment at the next notch.
To use all the notches on paper, you must comply with the following equation:
1mm + H ≤ L
The height of the printing area (H) can be increased to make no progress on alignment (D) but no further.
78
CUSTOM-Powered