1. INSTALLATION AND USE
3
1-
DPT100-B/I/BT
(4)
NOTE:
During the recharge operation it’s not possible turning the printer off.
WARNING
Incorrect battery recharge voltage (different from that given in tab.1.2) could seriously damage
the printer.
Tables 1.1 and 1.2 provide specifications for the battery recharger
N
I
P
L
A
N
G
I
S
T
U
O
/
N
I
N
O
I
T
P
I
R
C
S
E
D
1
C
I
R
V
+
R
E
W
O
P
e
g
r
a
h
c
e
r
y
r
e
tt
a
B
2
D
N
G
R
E
W
O
P
l
a
n
g
i
s
d
n
u
o
r
G
t
n
e
r
r
u
c
e
g
r
a
h
c
e
r
x
a
M
A
6
.
0
e
g
a
t
l
o
v
e
g
r
a
h
c
e
r
x
a
M
V
6
3
-
V
2
1
1.2.2 Information regarding battery use
•
Please note that the new NiMH battery reaches maximum performance levels only after having been
completely discharged and recharged at least two or three times.
•
Never use battery rechargers and/or batteries that are damaged or worn.
•
Battery life varies greatly depending, for example, on print density and the text to be printed.
•
Recharge times vary depending on depletion levels, type of battery and battery recharger used. Batteries
may be recharged and discharged hundreds of times, but they do wear out over time. When battery life
(both print and stand-by) is noticeably shorter than usual, it is time to buy a new battery.
•
Only utilize batteries that conform to specifications and only recharge them using battery rechargers
approved by CUSTOM ENGINEERING SPA.
•
When the battery recharger is not in use, unplug it from the electrical mains. If not used, even a completely-
charged battery will automatically discharge over time.
•
NiMH batteries last longer if you remember to completely discharge them every so often.
•
Extreme temperatures can affect battery charge levels—leave them to cool or warm as required.
1.2.3 Replacing batteries
Instead of the rechargeable battery pack supplied with the printer, 5 AA ALKALINE penlight batteries may be
used
(5)(6)
.
(5)
Note:
if batteries other than those supplied with the printer are used, the Battery parameter in setup
must modified and the settings changed to Alkaline if Alkaline batteries are used, or the to closest
reference value for other types of batteries (see sec. 1.3).
(6)
Note:
if Alkaline batteries are used it doesn’t make the recharge.
To replace batteries, proceed as follows:
•
remove the cover on the battery compartment (1) by unscrewing the screws (2) and, using a flat-head
screwdriver, pry open at points A and B (see fig.1.5).
(Tab.1.2)
(Tab.1.1)
Содержание s'print DPT100-B
