Cushman HAULER 1200, Руководство по ремонту, Страница: 131 / 176

B
ENGINE
Read all of SAFETY and this section before attempting any procedure. Pay particular attention to Notices, Cautions, Warnings and Dangers.
113
Repair and Service Manual
653045
ENGINE
GENERAL
For further engine information, see Engine Shop Rebuild
and Service Parts Manual.
FOUR CYCLE ENGINE
Engine Specifications
Engine Model .................................................. FJ400-D
Type..................................Four Cycle, Overhead Valve
Number Of Cylinders...................................................1
Displacement......................................................401 cc
Rated Horsepower................................................13 hp
Spark Plug Type......................................NGK BPR2ES
Spark Plug Gap.................. .028” - .031" (.70 - .80 mm)
Cooling..............................................Forced Air Cooled
Oil Filter.........................Cartridge Type Full Flow Filter
Oil Pump..........................Positive Displacement Pump
Engine Description
The engine is an air cooled, 4-stroke, OHV, single cylin-
der gasoline engine. It incorporates a pressure fed oil
pump with a cartridge type oil filter and a counter rotating
balance shaft.
POWERTRAIN MAINTENANCE
Access the powertrain by raising or removing the seat
and the truck bed. Some service procedures require the
vehicle to be lifted.
Refer to lifting the vehicle in the SAFETY section for
proper lifting procedure and safety information.
Checking the Oil Level
Do not overfill the engine. Too much
oil may cause the engine to smoke
or cause spark plug fouling.
NOTICE: Vehicles with the leaf springs mounted on
top of the rear axle will have an oil dipstick with an
H stamped into the top.
The oil level should be checked with the engine warm.
The vehicle should be on a level surface with the parking
brake engaged (Ref. Fig. 1). Allow adequate time for the
oil to drain into the crankcase before checking the oil.
1.
Clean the area around the oil fill cap.
2. Remove the dipstick and wipe clean with a lint free
cloth.
Fig. 1 Oil Dipstick
3. Insert the dipstick fully into the dipstick hole and
remove. Examine the level of the oil on the dipstick.
Fig. 2 Check Oil Level on Dipstick
The engine can be operated safely as long as the oil level
is within the safe operating range as indicated on the dip
stick.
Do not operate the vehicle if the oil
level is below the safe area indicated
on the dipstick .
Oil should be added to bring the level into the safe operat-
ing range. Remember that oil expands as it gets hot. Do
not overfill (Ref. Fig. 2).
4. Check that the oil cap is firmly in place.
5. The oil dipstick/fill cap must be in place before oper-
ating the engine. Failure to install the dipstick/fill cap
will result in oil becoming contaminated and/or oil
being discharged into the engine compartment.
Front of Vehicle
Maximum Oil Level
For Hot Engine
Do Not Overfill
Fill Cold Engine
To This Point
Safe
Operating Range
Hot Engine
Add Oil
Property of American Airlines