Cushman 2012 HAULER 1000, Руководство пользователя

Страница: 31 / 76

3 - 7
INTRODUCTION
Read all of this manual to become thoroughly familiar with this vehicle. Pay particular attention to all Notices, Cautions, Warnings, and Dangers.
3
• the electronic braking system is deactivated which allows the vehicle to be towed or roll freely
• the warning beeper is deactivated
With the switch in ‘RUN’ position:
• the controller is activated
• the electronic braking system and warning beeper features are activated.
18. Ash Tray
The vehicle is equipped with ash tray as an option.
19. Utility Bed
To reduce the possibility of severe injury or death, read, understand and follow the Danger label
affixed to the front of the load bed.
Never fill a gas can in the bed of a vehicle. Static discharge could ignite gasoline vapor and
cause an explosion.
A load bed warning label is affixed to the front of the bed. For safe operation of the vehicle, this label must be under-
stood.See the load bed warning label for maximum load.The load must be positioned in the bed as far forward as
possible, distributed in such a way that its center of gravity must not be higher than height noted on label, and
secured. Failure to follow these instructions may result in severe injury, damage the vehicle and/or cause the vehicle
to tip over. Use extra care when operating loaded vehicle. Do not permit any one to ride in the bed. Do not drive the
vehicle with the load bed raised or with the tailgate unsupported. When using a load bed, be sure to avoid backing up
to the edge of a drop off, such as a loading dock or ravine. A misjudgment of distance or an unstable surface could
result in the vehicle falling backwards. Always place a gas can on the ground before filling. Never fill a gas can in the
bed of the vehicle. Static electricity is built up during the fueling process and could discharge causing the gasoline
vapor to ignite.
20. Manual Lift Bed Operation
Exercise caution while operating the manual lift bed to ensure the bed is not released during lift-
ing or lowering procedure. Severe injury could result if bed is released and traps fingers or other
body parts.
To raise the manual lift bed, pull back on the latch release handle immediately behind the driver seat. Raise the bed
using the handle on the side of the bed.
To lower the manual lift bed, grasp the bed handle and lower the bed to the rest position. Be sure hands are not
trapped by the bed.
MAX
14
o
/ 25%
MAX
400 lbs.
180 kg
MAX
4 in.
10 cm
P
P
MAX
100 lbs.
45 kg
74821G06