cushion pack
cushion pack
cushion pack
cushion pack
cushion pack
cushion pack
cushion pack
cushion pack
cushion pack
cushion pack
CP 333 NTi
Operating Instructions – Start-up
Electrical connection - commissioning
A 230/240 Volt, 50/60 Hz, AC connection is required to operate the CP 333 NTi. A 2 metre
cable with a plug is connected to the CP 333 NTi 10 A „inert“ fuses must be provided by the
customer.
Commissioning
Connect plug to mains. Before putting the machine into operation, switch on at main switch
(5),the operating lamp (5) is lit. Then the machine can be switched on with the switch (4) – the
machine starts.
The cardboard material can now be inserted into the feed slot (1) and production of the
packaging padding can begin.
After pressing the Emergency-Stop switch (3), to switch on again unlock the Emergency-Stop
switch. Press the rocker switch (5) short to „R“ to restart (R=reset after pushed the
Emergency switch or after over loading the machine). The operating lamp (5) is lit again.
Then the machine can be switched on with the switch (4) on Pos. I - the machine starts.
Only press the Emergency Stop button in the event of danger -
do not use as an Off switch!
To switch the machine off, place the switch ( 4) and the main switch (5) off. The machine is
then completely disconnected from the mains!
When the CP 333 NTi is not in use, the main switch (5) must be switched off and prevented
from being switched on again where necessary.
If too thick cardboard is fed in, switch the machine off immediately at the switch (4) (push up
to position „0“) . Then briefly put rocker switch (4) in position „R“ (reverse/reset), switch
machine off again and the too thick cardboard can now be removed from the machine.
Disconnect the mains plug before opening the housing!
Rear
At the rear (2) the packaging padding material comes out automatically.
Caution – the padded material must always fall unobstructed out of the outlet
channel. Do not block the channel.
