CUSHCRAFT R9, Инструкция по сборке и установке

Страница: 15 / 16

14
FigureN
FigureO
#11 -BASE TO MAST ASSEMBLY
726 195726 “ V ” Bracket 4
118 010118 SS HEX NUT 5/16" - #18 8
119 010119 SS SPLIT LOCK 5/16" 8
WASHER
404 010404 U-BOLT 5/16-18 x 3-1/4" 2
(6.2 x 8.2 cm)
405 010405 U-BOLT 5/16-18 x 4-1/2" 2
(6.2 x 11.4 cm)
4079 194079 MOUNTING 1
PLATE -
326 290326 WARNING 1
LABEL -
405
404
119
726
726
4079
326
Attach the antenna base to your mast as shown in Figure N. First attach
the mounting plate (4079) with U-bolts (404), aluminum V-blocks (63), and
nut (389) to the antenna base. The bottom of the plate should should be
even with the bottom of the antenna to leave room for the radial clamping
system. Affix danger label (326) to the antenna so that it is easy to see.
When attaching
mounting plate to the mast use the (405) U-bolts, mast
clamps (726), and nut (389).
404
Line bottom
of plate up
with bottom
of antenna.
#12 - FEEDLINE
The R9 is designed for use with 50 Ohm coaxial cable terminated with a
PL-259 connector. The shortest length of cable will have the least loss.
A connector boot is included for use with your new antenna (figure O).
Slide the boot over the cable before attaching your PL-259. Coat only the
outside connector threads and shell with silicone grease. Do not coat the
center pin or receptacle. After the PL-259 is firmly screwed onto the
antenna connector, slide the vinyl boot over the connector and against the
connector bracket for a good weather-tight connection. After the antenna
is on the mast, tape the feedline to the mast.
If you plan to install the
antenna in a salty or corrosive environment, you may want to consider
coating it with a clear marine varnish or equivalent after it is assembled.
115 050115 CONNECTOR 1
BOOT
116 240116 SILICONE 1
PACKAGE
SILICONE GREASE
cushcraft
115
SILICONE
(116)
DO NOT COAT
CENTER PIN
WITH SILICONE !
SILICONE GREASE
cushcraft
KEY P/N DISPLAY DESC SIZE QTY
KEY P/N DISPLAY DESC SIZE QTY
118
4 PLACES
118
4 PLACES
4 PLACES
389
R9
118
405
726
726
119
4 PLACES
4 PLACES
Note: Apply liquid soap or anti-seize compound to
threads of U-bolts before attaching nuts
.