Curve D-DF Series, Инструкция по эксплуатации и техническому обслуживанию

Страница: 27 / 27

27
ref: MA-ED-0008-EN-V16.0-MIÑO DESCALCIFICADOR D-DF-M3 & D-UF-M3.pdf
8. The brine tank overflows.
a.
b.
c.
d.
Uncontrollable filling flow.
Air intake in the brine line.
Improper drain control for the
injector.
Drain control clogged with resin or
other debris.
a. Remove and clean salt
variable controller and
sphere.
b. Check all connections on the brine
line for leaks. Refer to the
instructions.
c. Check the controller is correct.
d. Clean the drain.
9. The system is using more
or less salt than was set.
a.
b.
c.
Value set incorrectly.
Foreign matter in the control which
makes incorrect flows.
Faulty control.
a. Set the value correctly
b. Remove the salt regulator and
wash the dirt off. Manually
programme the system to brine
extraction to clean the salt
regulator. (After this, set the
controller to "Vacuum" to remove
the brine from the tank.).
c. Replace the faulty parts.
10. Intermittent or erratic brine
removal.
a.
b.
Water pressure too low.
Faulty injector. ®
a. Set the pump to maintain at least
2.5 kg / cm² in the softener.
b. Replace the injector and its lid.
11. No conditioned water after
regeneration.
a.
b.
c.
The system didn’t regenerate.
There’s no salt in the brine tank
Dirty injector. ®
a. Check there is a power supply.
b. Add salt in the brine tank.
c. Remove and rinse the injector
and mesh.
NOTE 1
: The use of the resins cleaner HW77 (registered trademark by HYDRO-WATER, SL) is recommended.
Warning : Use of resins cleaners in unventilated ambient can damage the timer.