Curtis SERA2B, Руководство по обслуживанию

Страница: 7 / 24

7
Your Curtis G4/Gold Cup Series Brewer is factory preset for optimal performance.
After connection to water and power; turn on the brewer at the rear toggle switch. You will hear a beep and the status lights will come on for
a moment.
The screen will display . Next is displayed. Water will fill the tank (3-5 minutes depending on water flow rate).
When the proper level is reached will appear on the screen. It takes approximately 45 minutes to reach the set point tempera -
ture.
The screen will display when temperature reaches the set point. The unit is now ready to brew.
READY TO BREW
1. Brewer should be ON. Confirm this at the toggle switch on the back of the water tower, at the lower right side. The touch-screen should
read Ready to brew.
2. Center an empty coffee container beneath the brew head.
COFFEE BREWING INSTRUCTIONS
5. Slide the filled brew basket into the brew
rails on the brew head.
3. Place a clean filter into the brew basket. 4. Fill the filter with the proper amount of
ground coffee.
6. Start the brew cycle by holding your
finger on the desired brew icon. As soon
as you hear the click of the brew valve,
the brew cycle has started and you can
lift your finger.
Brew Code: When a brew button is pressed,
a keypad may appear on the screen. This is
the brew lock-out feature. When this keypad
appears, you must enter a code to continue.
CAUTION: As soon as you enter the brew
code, brewing will start.
The default is OFF. See page 8 to enable, dis-
able and set the brew code.
During the brew cycle, a coffee cup icon will
appear on the screen and a brew timer will
count down the time remaining for the brew
cycle.
WARNING – TO AVOID SCALDING, AVOID SPLASHING. Do not remove the brew basket while Brewing... appears on the display.