Curtis RCD888, Инструкция по эксплуатации

Страница: 6 / 13

Remote Control
1. Open the battery compartment cover.
2. Insert two AAA (Um4) batteries (not included )to match the polarities as indicated inside the battery
compartment.
3. Close the cover.
NOTE: When the batteries become too weak, the operating distance of the remote controller is greatly
reduced and you will need to replace the batteries.
Operating the remote control
Point the remote control at the front of the CD micro system to operate. The IR sensor is located below
the LCD display.Do not block the path of the beam from the remote control to the unit . Dark walls,
direct sunlight or very bright light will reduce the sensitivity of the IR sensor.
5
Setting the Clock
The clock can be set by using the buttons on the front of the unit or the remote control.
Setting the Clock using the Unit Controls
1. At STANDBY mode press and hold the PROG/MEM button for 3 seconds. The display will show
either
24H or 12H .
2. Release the PROG/MEM button and use either of the or buttons to select the clock mode
you require, either 12 or 24 hour clock.
3. Press the PROG/MEM button. The display will show the time with the hours flashing on and off.
4. Use either of the or buttons to select the hour and press PROG/MEM the hour stops
flashing and the minutes start flashing. Note that for the 12 hour clock mode AM and PM are
displayed.
5. Use either of the or buttons to select the minutes and press the PROG/ MEM button.
The clock is now set.
Setting the Clock using the Remote Control
1. At STANDBY mode press and hold the PROGRAM/CLOCK button. The display will change to flash
either
24H .
2. Release the PROGRAM/CLOCK button and use the or buttons to select the clock mode
you require.
3. Press the PROGRAM/CLOCK button. The display will show the time with the hours flashing on and
off.
4. Use the or buttons to select the hour and press the PROGRAM/CLOCK button the hour
ceases to flash and the minutes start flashing.
5. Use the or buttons to select the minutes and press the PROGRAM/CLOCK button.
The clock is now set.