Curtis PL4210A, Инструкция по эксплуатации, Страница: 34 / 35

• Make sure the AC power cord is connected.
• Turn on the unit.
• Remove any obstacles between the remote and the unit.
• Use the remote near the unit.
• Point the remote at the remote sensor on the unit.
• Replace the batteries in the remote with new ones.
No power.
TV
SYMPTOM CAUSE AND REMEDY
( )
TROUBLESHOOTING GUIDE
No sound.
No picture or sound.
• Check the direction of the antenna and adjust it if necessary.
• Make sure the antenna cable is firmly connected.
• Make sure all input cables are firmly connected.
• Increase the volume.
• Check the PICTURE setting within the PICTURE menu.
• Make sure the unit is plugged in and turned on.
• Make sure that the TV mode is selected.
• Try a new channel to check for possible station trouble.
• Make sure the antenna is connected properly.
• Increase the volume.
•
• Make sure all cables are firmly connected.
• Check for local interference.
• Make sure there are no unshielded electrical devices nearby
that are causing interference.
• Turn the TV off for 30 minutes, then try it again.
• Under the influence of electrostatic phenomenon, the product
may malfunction and require user to power reset.
• Unplug and re-plug the AC power cord.
• Check to make sure the program you are watching is broadcast
in Color and not Black & White.
• Check whether the mute function has been activated on the
Remote Control.
Stripes on screen • Adjust the impulse phase may decrease stripes. RGB in
（ ）
The top of the monitor
• It may occur during long-time working. It's not a defect.
gets hot
.
Make sure the antenna or audio/video source device is
working properly.
Unable to select a
certain channel. The channel may be skipped. Choose this channel by
directly selecting the buttons from the remote control.
•
The remote does
not function.
Bad Picture
(snow, multiple images,
distortion, blurry)
Black and
white picture.
Colored patches
of picture.
Panel function key does
not respond correctly.
30
Disorder display
at power on.
•
•
This may be caused because of a very short interval
between POWER OFF and ON.
Unplug the power and restart.
All manuals and user guides at all-guides.com