Curtis 1POLXP1000RP, Инструкция по установке и эксплуатации

Страница: 3 / 6

KIT INSTALLATION
3 of 6
STEP 1: (KIT INSTALLATION)
If installing multiple Curtis Polaris Ranger 1000 kits,
install in the following order.
1.Doors
2.Windshield
3.Rear Panel
4.Roof
1.1 Per figure 1.1, install both lower mounting bracket
assemblies to the inside surface of the rear panel
using hardware listed below. Make sure that the
rubber washer is against the outside surface of the
rear panel.
Hardware Used Qty
5/16 - 18 X 1 Hex Head Flange Screw 4
5/16 - 18 Hex Flange Nut 4
5/16 X 1 - 1/4 Steel Washer 4
5/16 X 1 - 1/4 Rubber Washer 4
Tools required
1/2” socket and wrench
1.2 Per figures 1.2a and 1.2b, install rear panel with
brackets onto the vehicle ’ s frame behind the seat
back. Then flex the rear panel and hook it around
the rear panel header. If the rear panel is loose in
the vertical position, adjust the lower mounting
brackets to take up the vertical play.
Tools required
1/2” socket and wrench
1.3 Per figure 1.3, install 2 clamp bracket assemblies to
the inside of the rear panel making sure that the
bracket is touching the inside surface of the ROPS.
Hardware Used Qty
5/16 - 18 X 1 Hex Head Flange Screw 2
5/16 - 18 Hex Flange Nut 2
5/16 X 1 - 1/4 Steel Washer 2
5/16 X 1 - 1/4 Rubber Washer 2
Tools required
1/2” socket and wrench
1.4 Per figure 1.4, if the Curtis Roof is being installed
on this vehicle, a piece of 3/4" side bulb rubber with
2 wipers will need to be installed on the rear flange
of the roof (rubber should be facing forward). If not,
this kit installation is now complete.
Fig. 1.1 (Install Brackets onto Rear Panel)
Fig. 1.2a (Hook Rear Panel onto Frame)
Fig. 1.2b (Flex rear panel into the inside of header)
Fig. 1.3 (Install Clamp Brackets)
Clamp Bracket
Fig. 1.4 (Install rubber on roof, if roof is being installed)
Rubber from Kit
Rubber
this side
Rubber Facing Forward
Vehicle ’ s Frame
Hook Behind
This Lip
Hook to inside of header