Curtis Dyna-Fog SUPERHAWK II 1 Series, Инструкции по установке, эксплуатации, обслуживанию и техническому обслуживанию

Страница: 35 / 66

Figure7
AFTER EVERY 25 HOURS OF OPERATION CLEAN THE
FORMULATION INJECTION ORIFICE
1. Disconnect the Formulation Injection Line at the injection end and then remove the
elbow assembly (Fig. 7).
2. Insert a wire through the Coupling into the engine tube to remove carbon deposits.
3. Reassemble the Elbow and the Formulation Injection Line. Apply a pipe sealant to
the pipe threads of the nipple prior to the assembly.
CHECK THE FUEL FILTER
Inspect the Fuel Filter (Fig. 4) in the fuel line. If it is dirty, replace the filter for a new one
(P/N58316). Inspect the filter located within the carburetor (see Figure 13 for location).
CHECK THE BATTERIES
No set period of time can be established for the replacement of the "D" size batteries,
but the spark intensity should be checked whenever the machine does not start easily.
See TROUBLESHOOTING SECTION concerning the testing of the electronic ignition.
Page 35
35