INSTALLATION WALKTHROUGH:
For more information log onto www.curtmfg.com, & for helpful towing tips log onto www.hitchinfo.com
3. On the heat shields, locate and remove (4) nuts
using an 8mm socket, (2) bolts using a 10mm
socket, (2) screws using a T25 torxbit socket,
and (1) metal clip from the heat shield on each
side. Set aside for later reinstallation.
8"
4"
4. On the heat shields mark out a 4" x 8" section
using masking tape and trim out using aviation
shears. Reinstall heat shields using hardware
from Step 3.
5. Raise hitch into position aligning the rear-most hole of the
hitch with the existing hole on the frame to use as a template
to mark out the forward most hole on each side of the hitch.
Lower hitch and drill out the marked areas using a 1/2" drill
bit.
NOTE
: for ease of drilling push the exhaust towards the
side of the vehicle.
6. Use the die grinder to enlarge the slotted hole to
a 1.125" hole. Verify that provided bolt head will
fit through hole before moving on to next step.
Содержание 11454
Страница 5: ......
