58963-INS-RB
•
PAGE 3
Step 6
From under the vehicle, route the
harness with the green wire along the
backside of the bumper to the passenger
side of the vehicle. Secure any loose
wires with the provided cable ties.
Repeat steps 3 and 4 with
the green wire of the harness.
Step 8
Route the 4-flat wire in between the rear drive
line mounts and the body. Be sure to zip tie in
place and keep the wiring away from hot spots,
pinch points or moving objects.
Step 9
Once to the front side of the transaxle, locate
the plastic skid plate. Remove the four 10 mm
bolts, one 10 mm nut, and one 13mm bolt.
Step 7
Locate a grounding point near the box such as an existing screw or bolt in the frame of the vehicle or drill a 3/32” pilot hole.
The area should be free from rust, dirt, and paint (Use abrasive pad/paper to remove rust and paint). Secure the white ground
wire with the ring terminal on the existing fastener or with the provided ground screw.
WARNING
Check for miscellaneous items that may be hidden behind or under any surface before drilling to avoid damage and / or personal injury.
NOTICE
Once the custom wiring harness is installed, verify that the harness is functioning by attaching the 4-flat to any vehicle with
functioning trailer lights. The taillights on the tow vehicle should function along with the taillights on the towing vehicle.
Install your vehicle RV wiring harness add-on, allowing your RV harness to also act as a trailer light harness.
Step 5
Once you reach the taillight opening, insert
the custom wiring harness into the factory
wiring. Make sure the connectors are fully
inserted with the locking tabs in place. Install
the taillight back into the taillight housing.
