Parts List
DESCRIPTION
PART NUMBER
QTY
ITEM
BOLT, CAR,1/2-13 UNC,1-1/2,GRD8,YZ
10-10287
2
1
NUT, SER-FLANGE,1/2-13 UNC,GRD8,YZ
20-00062
2
2
.250 x 1.00 x 3.00" SQUARE HOLE SPACER
CM-SP6
2
3
FHSCS, 3/4-10 UNC, 2, GR8
10-10346
1
4
1/2" FISHWIRE
1_2 FISHWIRE
2
5
GROSS LOAD CAPACITY WHEN USED AS A WEIGHT CARRYING HITCH: LBS. TRAILER WEIGHT & LBS. TONGUE WEIGHT.
WARNING: *** DO NOT EXCEED VEHICLE MANUFACTURER'S RECOMMENDED TOWING CAPACITY ***
FOR MORE INFORMATION LOG ONTO WWW.CURTMFG.COM
HAVING INSTALLATION QUESTIONS? CALL TECHNICAL SUPPORT AT 1-877-287-8634
HITCH WEIGHT: LBS.
INSTALL TIME
PROFESSIONAL: MINUTES
NOVICE (DIY): MINUTES
INSTALL NOTES:
INSTALLATION STEPS
PERIODICALLY CHECK THIS RECEIVER HITCH TO ENSURE THAT ALL FASTENERS
ARE TIGHT AND THAT ALL STRUCTURAL COMPONENTS ARE SOUND.
CURT Manufacturing LLC., warrants this product to be free of defects in material and/or workmanship at the time of retail purchase by the original purchaser.
If the product is found to be defective, CURT Manufacturing LLC., may repair or replace the product, at their option, when the product is returned, prepaid,
with proof of purchase. Alteration to, misuse of, or improper installation of this product voids the warranty. CURT Manufacturing LLC.'s liability is limited to
repair or replacement of products found to be defective, and specifically excludes liability for incidental or consequential loss or damage.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C.Regulation V-5 and SAE J684.
5,000
500
7
15
JEEP GLADIATOR
10/23/2019
13434
30
Scan
for more
information
1. Drill through rear bumper cover using a hole saw at predefined dimple located in center of cover, then insert 3/4"
bolt.
2. Fishwire CM-SP6 spacer and 1/2" carriage bolt through end of cross member on both sides.
3. Raise hitch into position and loosely secure with 3/4" bolt followed by 1/2" flange nuts.
4 Torque 3/4" hardware to 320 lb-ft and 1/2" hardware to 110 lb-ft.
NO FRAME DRILLING
FISHWIRE HARDWARE
1
3
2
REAR CROSS MEMBER
5
4
TOOLS REQUIRED
3/4" SOCKET
RATCHET
TORQUE WRENCH
1/2" HEXBIT
2" HOLE SAW
POWER DRILL
1/4" DRILL BIT
SAFETY GLASSES
Содержание 13434
Страница 3: ......
