Currys Essentials CDWTT13, Инструкция по эксплуатации

Страница: 11 / 32

INSTALLATION
11
• Secure the water drain hose to the waste pipe
to avoid it coming off during the washing
process.
7. Make sure your plumbing is suitable for use with
the dishwasher. If in doubt contact a qualified
plumber. This unit MUST BE connected to COLD
WATER MAINS using the new water inlet hose.
OLD HOSE SETS MUST NOT BE RE-USED. The
water pressure from the water mains needs to
be at a minimum of 0.04 MPa and a maximum of
1.00MPa.
• Connect one end of the safety water supply
hose to your dishwasher, and then connect
the other end of the hose to your water
mains. Please ensure the black rubber seal is
in place.
• After connecting the hose, turn on your water
mains and check for leaks.
• Connect the dishwasher to the mains socket.
water mains
water supply hose
Y-Adaptor
(not included)
Connect to
another
appliance
if required.
You may use a Y-adaptor (not included) for an additional water feed for
another appliance, for example a washing machine. This is only applicable for
cold water mains. A Y-adaptor is available from most DIY stores.
• The waste pipe must only be connected to
the foul drains and not the surface water
drainage system.
• The water drain hose should be placed lower
than 10cm from the table top and must not
be extended, otherwise the unit may not be
able to expel the waste water properly.
• You may use the u-shaped drain hose holder
to secure your drain hose and to avoid
bending it.
• Please close the hydrant after use.
• Do not bend your drain hose.
• Do not lift the drain hose higher than 10 cm
from the table top, otherwise the unit may
not be able to expel the waste water properly.
max.
10cm