POWER
MIN
MAX
O I
POWER
MIN
MAX
O I
GB-3
GB-2
GB-1
UNPACKING
Remove all packaging from the unit. Retain the packaging. If you dispose of it,
please do so according to any local regulations.
The following items are included:
4.
If items are missing or damaged, please contact Partmaster (UK only).
Tel: 0844 800 3456 for assistance.
OVERHEAT PROTECTION SYSTEM
heater exceeds a certain limit. In the event of overheating, the radiator will
The radiator will then operate again as normal.
CLEANING AND STORAGE
1. Always remove the mains plug from the
mains socket and allow the radiator to cool
down before cleaning the radiator.
2. Wipe the radiator with a soft damp
(not wet) cloth.
3. Store the radiator in a clean dry place.
The Main Unit
Front Foot
Rear Foot
Carry Handle
Radiator Fins
Rear Foot
Pilot Light
Front Cover
Front Foot
Thermostat
Control
Power Switch
Thermostat
Control
Pilot Light
Power Switch
Do not operate without both feet attached. Only operate the radiator
in an upright position (feet on the bottom, controls on the top);
any other position could create a hazardous situation.
Do not immerse the radiator in water. Do not use any cleaning
chemicals such as detergents and abrasives. Do not allow the interior
to get wet as this could create a hazard.
PRODUCT OVERVIEW
CONTROL PANEL
ASSEMBLY
1. Unpack the radiator and remove all the parts from the packaging.
2. Place the radiator body upside-down on a scratch-free surface, making sure
it is stable and will not fall.
3. Insert the front foot horizontally into the bottom of the front cover until it
clips into place.
OPERATION
1.
wallcovering before plugging your radiator into the mains socket.
2. Switch the Power Switch to the “ I ” position.
3. Turn the Thermostat Control to the desired position. It is recommended to
rotate to “MAX” position to get the radiator to pre-heat. It will take 5-10 minutes
for the radiator to pre-heat.
4. When the room reaches the desired temperature, turn the Thermostat Control
5. If the room temperature falls below the desired temperature, the radiator and
power indicator will turn on again until the room temperature reaches the
desired temperature.
HINTS & TIPS
My radiator does not work when I turn it on
1. Check that your radiator is plugged in and the power is turned on at the
mains socket.
2. Set the temperature to the highest setting.
3. Check if the thermostat setting is too low.
4. Try replacing the BSI or ASTS approved 13 Amp BS1362 fuse in the plug.
5. If the radiator still doesn’t work, do not try to repair the radiator yourself.
1. Unplug your radiator and allow it to cool down.
2. Inspect your radiator.
3.
radiator to a better ventilated location.
4. If there is any sign of physical damage (e.g. melting, or burning of the
case), do not attempt to use your radiator. Please leave all maintenance
SPECIFICATIONS
Power supply : 220-240V~ 50Hz
Power Consumption : 700W
No. of Fins : 7
POWER
MIN
MAX
O I
O
I
MIN
MAX
POWER
C7MOR12_IB_RC_20130716_Shaun.pdf 2 16/07/2013 12:25 PM
