E3Metro Assembly Guide 2013
OM references to r71
April 4, 2013 12:17 PM
Turning on the headlight
and LCD backlight
Hold “–” for 3 seconds to turn on
the LCD backlight and the bicycle
headlight/taillight (if present).
The backlight will not function
unless the display is mounted on
the bike (with a battery installed).
Hold “+” for 3
seconds to change
from PAS to POD.
In PAS mode
, the
motor will activate when
the system senses the
rider pedaling.
Use the “PWR LVL”
display function to
choose between light
assist, medium assist, and strong assist.
The throttle acts like a “boost”, allowing full control over 0-100% of motor
power at any time, regardless of power level.
In POD mode
, only the throttle controls motor speed. There is no power
level setting in this mode, as the throttle can always apply 0-100% of motor
power. The torque sensor is disabled, and there is no need to pedal.
Changing the assist mode
Tap SET to cycle
between functions.
Using the display functions
To reset all trip data, hold “+” and “–” together for 3 seconds.
Available in PAS mode only; sets
the strength of motor assist.
Displays the distance traveled
on this trip.
Displays the ride time for this
trip.
Displays the average speed for
this trip.
Displays the maximum speed
recorded on this trip.
Odometer; displays the bicycle’s
total mileage.
Displays the total ride time for
the bicycle.
Displayed
Level
Motor output
1
40%
2
60%
3
80%
4
100%
Power levels
