RMB Battery Pack Swap and Charge, June 9, 2009 4:25 PM
Currie Technologies
®
Use only a Currie Authorized 24V SLA Smart Charger to charge the batteries. Using any other charger may damage the batteries and void your
warranty. The charger unit has lights that show the battery charge status. Refer to the instructions that appear on the charger unit.
Flip the handle up to expose the charger port
1.
Attach the charger to the charger port
2.
Plug the Battery Charger’s AC plug into a standard, grounded 110V AC wall outlet. If the power to the outlet is controlled by a switch be sure
3.
the switch is “ON”. Let the batteries charge until the charger lights indicate that the batteries are fully charged, then unplug the charger from
the scooter and the wall outlet.
Always store SLA (Sealed Lead Acid) batteries with a full charge. Fully recharge after each and every ride. If you leave the batteries in a run-down
condition it will shorten their life expectancy. The charger may get warm to the touch, so make sure you charge them in an open area and do not lay
anything on the charger unit while charging. Although you cannot over-charge the batteries using the Currie “Smart Charger”, we recommend that you
do not leave the charger plugged in for more than 24 hours.
2
1
3
CHARGING THE BATTERY PACK
