9.
Plug the LOOP® IC controller into Port #1 on
the Orbit IC manifold HUB.
If using the optional
remote IR sensor, plug into Port #2.
10.
Use either the velcro tape included with the
LOOP® IC controller or install the controller
mounting bracket to the desired location
following the included instructions.
11.
Unpack IR remote and remove clear tab
located at the bottom of the remote. Press
the red POWER key located in the top
right corner and ensure to ensure the
controller and remote are communicating.
12.
Plug surge protector into a GFCI protected outlet
and ensure drip loop is in place. CAUTION:
This product MUST be plugged into a GFCI protected outlet.
13.
Toggle the surge protector POWER switch to the ON
position. Ensure the green indicator lights on all power
supplies illuminate and the LOOP® IC controller and
HUB indictor lights all turn On.
14.
Install Power Center to stand wall
by squeezing each
side of the Power Center inwards and aligning the
mounting slots with the wood mounting screws.
Power Center should flex out when released and be
mounted to stand wall. (See below)
Power Center Installation
P1
P3
P2
L1
L2
LOOP® Marine Bundle Kit
!"
PORT #2
IR Sensor
(Optional)
PORT #2
LOOP
® IC
Controller
Orbit Marine IC
Manifold HUB
eFlux Wave Pump
Manifold HUB
eFlux DC Pump
Manifold HUB
!
"
#
POWER
Remove
clear tab
AC Power
GFCI Outlet
Use only with GFCI
Protected AC Outlet
Ensure use of drip
loop for all cables
Surge Protector
P1
P3
P2
L1
L2
P1
P3
P2
L1
L2
+
Wood
Screw
+
Wood
Screw
+
Wood
Screw
+
Wood
Screw
Squeeze side panels slightly together
Side panels will ex out when released
+
Wood
Screw
+
Wood
Screw
+
Wood
Screw
+
Wood
Screw
10
Install controller
9
Plug in controller
11
Remove IR Remote clear tab
Press Power Key
12
Plug surge protector
into GFCI AC outlet
14
Install
Power Center
Page 4
