6
6. Adjust the bend degree indicator by hand (see Figure 5a) so that it is at the
zero (ø) position when the shoe hook first makes contact with the conduit.
7. Pull the ratchet handle down and return to the up position. Repeat until
you have completed the desired bend.
NOTE: Springback compensation is not calculated on the bend degree
indicator. Refer to the springback chart on page 8 to achieve your desired
degree of bend.
8. To remove the bent conduit, raise the ratchet handle to the up position and
remove the ratchet handle from the ratchet arm. While holding the bent
conduit, slowly rotate the bending shoe in the counter-clockwise direction
and remove the bent conduit.
NOTE: When not in use, the ratchet handle and ratchet arm MUST remain
in the down position.
OPERATING INSTRUCTIONS –
CONTINUED
Remove the ratchet handle
before removing the bent conduit.
CAUTION
