2
3
APPLY CONDUCTIVE
SPRAY TO RUBBER
ELECTRODES
5
TURN DEVICE ON AND
SELECT INTENSITY
7
SELECT PULSE WIDTH
The pulse width is adjusted from 50us to 300us. Press
the SET button to enter this menu, then press the
s
and
t
buttons to adjust the setting. Unless other-
wise instructed, a setting of 70-120us is suggested.
8
SELECT PULSE RATE
9
SET THE TIMER
The treatment time is adjustable from 1 to 60 minutes,
or Continuous (
C
). Press the
s
and
t
buttons to adjust
the setting. Your settings will be stored permanently
unless they are adjusted again.
6
SELECT
THERAPY MODE
Please see page 22 of your TENS 7000 To Go™ Instruction Manual for troubleshooting tips.
PROBLEMS WITH YOUR DEVICE?
Steps 1 – 4 should be performed with the device turned OFF.
Once the unit has been turned ON, do not remove the belt
without first turning OFF the device.
IMPORTANT!
SOLUTIONS
TM
A Roscoe Medical Company
CURRENT
QUICK REFERENCE GUIDE
PAGE 2
There are 5 modes available:
Burst, Normal,
Modulation, SD1
and
SD2
. Press the MODE button
and continue to press until you have reached your
desired setting.
1
CONNECT LEAD WIRES
TO BELT WIRE SNAPS
The stimulation output will increase as the dial is
turned clockwise or to a higher number.
1 = Weaker 8 = Stronger
By turning the
controls clockwise,
the appropriate
channel is switched
on and the indicator
of power (CH1 and
CH2) is revealed in
the LCD.
The pulse rate is adjusted from 2Hz to 150Hz. Press the
SET button to enter this menu, then press the
s
and
t
buttons to adjust the setting. Unless otherwise
instructed, a setting of 70-120Hz is suggested.
ON/
Increase
Continuous
Connect snap wires to metal snaps located on the back
of the belt. Securely connect the lead wires to the snap
wires. Make certain no bare metal of pins is exposed.
Select one of
the two available
channels and
insert the lead
wire firmly into
the socket.
CONNECT LEAD WIRES
TO DEVICE
Apply two pumps of conductive spray to each rubber
electrode pad before placing belt around waist.
4
PLACE BELT
AROUND WAIST
With the electrode
pads facing toward
your body, position
the belt on your
lower back. After
a comfortable fit
has been achieved,
fasten belt by
overlapping the
Velcro® closure
in front.
