![Current Audio WSLCR650FL Скачать руководство пользователя страница 3](http://html.mh-extra.com/html/current-audio/wslcr650fl/wslcr650fl_installation-manual_2698679003.webp)
WSLCRFL Series In-Wall Speaker
User’s Installation Guide
WSLCRFL Series Rev2 062911 RPA
Dog Legs (6)
3 Prepare FastLoc
™
Speaker for Install
Remove the grille by slightly applying pressure either to the top or bottom on the short side of the grille then slide the grille up or down about
¾”. When the grille tabs are aligned with the speaker notches the FastLoc
™
grille can be removed. Loosen the six (6) Dog-Leg screws a ½ turn
counterclockwise with a #2 Philips screwdriver.
4 Install FastLoc
™
Speaker
Hold the speaker by the Locking Rim as shown. Do Not put fingers into the tweeter material in the
center of the speaker.
WARNING! Denting or deforming the tweeter dome will change the acoustics of the speaker.
Insert the connected speaker into the cut-
out hole so the tweeter bridge is about 45” off the floor for
Left or Right. Mount the Center speaker above or below the TV, and as close to the sitting ear level as
possible. With a #2 Phillips screwdriver, tighten the six(6) Dog-leg screws (clockwise) until the Dog-
legs open and clamp the speaker to the drywall.
WARNING: If using a power drill or electric
screw gun use the lowest torque setting.
Over tightening may cause improper fit of the grille,
damage to drywall and or damage to speaker.
Adjust the Tweeter position to your ear area at the “Sweet Spot” by slighting pushing on the outer
edge of the tweeter with your thumb.
Make the crossover Contour Switch adjustments before installing grille.
The Bass and Treble switches on the Tweeter Bridge (as shown in section 4) allows for contour
adjustment. Moving the switch to (+) increases the Bass or Treble 3db and to (-) reduces it by 3db. In
the (0) setting you achieve a flat frequency response.
NOTE:
If you have blown-in insulation and/or a potential rodent problem I suggest you install the SpeKap.
It is a breathable membrane that will keep rodent droppings, debris, and insulation from entering the back
of the speaker that could change the performance of the speaker. See figure below .
Tweeter. Push Here
Baffle Housing
Contour Switches
Specifications subject to change without notice.
Dog-Leg Screws
Turn CCW to Loosen
Locking Rim
Hold Here
Turn Front (6) Screws CW to Expand
Dog-Legs and Tighten
SpeKap
Breathable Membrane
Keeps Debris, Rodent Droppings
and Insulation out of the Speaker
FastLoc
™
Grille
Push Down
Here
OR
Push Up
Here
To Unlock Grille
Alignment Tabs
On Reverse