Features
•
Dual Power Mode -
Input power is switchable from 110VAC to 220VAC.
•
3 Prong Plug -
Grounded input power for Safety.
•
Master Power Switch -
Rear panel switch to cut power for service or hook-up.
•
Multi-Stage Protection -
Each pair of channels/zones is individually protected with internal circuitry
and is indicated on the front bi-color LEDs. The amp will shut down a bad zone if it senses a short
or is overdriven. ONLY the channels that are affected will turn Off and indicates by the LED turning
from blue to red thus pointing to the channel in distress. The remaining zones will run unaffected
and continue to provide sound without shutting down all zones.
•
Global and/or Individual Inputs -
One input signal can be universally distributed to all zones or the
user can individually dedicate one or more zones to have a unique separate input. The other zones
will still play the global input.
•
Gain Adjustments -
There is a global gain control that sets the maximum level to all zones. In addi-
tion, each zone has its own separate gain control to allow the user to customize each zone to match
the acoustics of that room. This also sets the maximum loudness of each room.
•
Installer Friendly Connections -
Each speaker channel has pull off plugs to allow the user to make
wire connections up to #14 gauge with positive screw down terminals. The IEC power cord can be
disconnected at the amp for easy service. All inputs are made by easy connect gold plated RCA
plugs.
•
Bridging -
If more power is required for perhaps an outside area, two channels may be combined
(Bridged) to provide 140 watts at 8 ohms. This is accomplished simply by a selector switch at each
zone. CAUTION: Turn power off when making change and always maintain an 8 ohm load when
in the Bridge mode.
•
Rack Mount -
Packed with each amp is an accessory pack that include brackets allowing the amp to
be rack mountable. This is accomplished by attaching the rack ears with the 4 included screws.
•
Power Mode -
Power On has three modes. (1)It can toggled ON/OFF by the front power switch
and is indicated by the corresponding LED. (2)It can also be triggered ON/OFF by a 12 VDC
signal on the rear 3.5mm Trigger in jack. Front Power button must be in standby mode to operate
trigger. LED must be red. The tip of the plug is (+). (3)It can be triggered ON by Music Auto Sense.
In this mode unit will turn OFF after a 10 minuet delay of no signal.
www.currentaudio.com
1890 Cordell Court, Suite 105., El Cajon, CA 92020 • 866-927-7181
©2014 Current Audio - All Rights Reserved.
Rev. 01, 04/14
4
